The V-3000 Series Pneumatic Actuator can position steam or water valve-modulating plugs in response to a pneumatic signal from a controller. Refer to the V-3000 Pneumatic Valve Actuator Exposed or Enclosed Product Bulletin (LIT-977250) for important product application information.
- Molded synthetic rubber diaphragm design provides a constant effective area throughout the valve stem strokeÃ¯ die-cast aluminum housing coated with corrosion-resistant finish
- Remove or reposition actuator by loosening a single set screw
- Easily field mounted to the valve bonnet with a single set screw
- Can be mounted to any of the V-3000, V-4000, or VT Series Valves (except V-3854)
Used on 1/2" Flare Valves, VT Series Valves, and 3/4 to 1-1/2 Cage Trim Valves. This actuator is not used with VG7000 Series Valves.
If the V-3000 Series Pneumatic Actuator fails to operate within its specifications, replace the unit. For a replacement actuator, contact the nearest Johnson ControlsÃ† representative.
|Weight||1 Pound (lb.)|
|Height||5 Inches (in)|
|Width||4.2 Inches (in)|
|Length||5.1 Inches (in)|